rig out

英 [ˈrɪɡ aʊt]

美 [ˈrɪɡ aʊt]

网络  打扮; 装配; 装扮

英英释义

verb

• put on special clothes to appear particularly appealing and attractive
  1. She never dresses up, even when she goes to the opera
  2. The young girls were all fancied up for the party
  Synonym:overdressdress upfig outfig updeck upgussy upfancy uptrick updeck outtrick outprinkattireget uptog uptog out

双语例句

• Based upon the analysis of the working conditions in the tunnel excavations, a principle design, hydraulic value design and system integration design of hydraulic drive system of cutter head for simulator test rig is carried out theoretically with electro-hydraulic proportional control technique.
  论文以盾构模拟试验平台为研究对象，模拟实际盾构施工过程中的工况要求，采用电液比例控制技术对盾构模拟试验平台刀盘液压驱动系统进行了原理设计、液压阀块设计和系统集成设计。
• A test rig is set up and the experiment on the valve is carried out at the room temperature and high temperature. The experimental proportional characteristics are obtained and compared with the simulation results.
  搭建了试验台，分别在常温与高温条件下进行阀的特性试验研究，给出了比例阀的比例特性曲线，并与仿真结果进行了比较。
• The sergeant will rig you out with everything you need.
  中士将发给你一切必需的物品。
• The Floormen remove the rig tongs and tie them back safely out of the way.
  钻工打开大钳，放置到安全位置并拴牢。
• In the paper, a modal analysis of JJ 160/ 41-k rig derrick is carried out by applying I-DEAS software being of mighty finite clement analysis function.
  文章运用I-DEAS软件强大的有限元分析功能，对JJ160/41-K型钻机井架进行模态分析。
• By taking the three kinds of design schemes of a drilling rig rotary table as an example, it is proved that ideal design scheme can be sought out conveniently by using the variable element method.
  最后以石油钻机转盘3种结构方案为例，说明了应用变元法可以很方便地得到理想的优选方案。
• The rig tongs hinge pin, latch lock and springs must be inspected at regular intervals and changed out if excessive wear is encountered.
  必须定期检查大钳的折页销子，扣合头和弹簧，如果出现磨损超标，就更换。
• The following aspects have been carried out in the design of an AC servo feed system experiment rig based on Motion Controller with FPGA in this thesis: ( 1) A kind of AC servo feed system scheme is given out.
  本文在设计这个基于FPGA运动控制器的交流伺服进给系统试验台上主要做了以下方面的研究：（1）设计了一种交流伺服进给系统方案。
• On the basis of cold qualification test, the irradiation tests ( closed capsule and sweep loop rig) of the coated fuel particles for 10 MW high temperature gas-cooled reactor ( HTR-10) were carried out.
  在冷态性能检验合格的基础上，进行了10MW高温气冷堆包覆燃料颗粒的静态辐照试验和动态回路辐照试验。
• The load analysis and calculation for the rig under the wave action are carried out. Based on this, three dimensional finite element strength analysis is conducted.
  展开了该平台波浪载荷的分析计算，在此基础上对主体结构进行了三维有限元强度分析。